Disclaimer: This Installation Guide is for installation of our Petite Size window boxes directly to the exterior of buildings that have wood, stucco, HardiBoard, vinyl or similar siding. Its suggested you not work alone, use proper lifting techniques and exercise due caution in and around your work area. The instructions which follow are suggested guidelines only as the construction and condition of your walls may vary. A window box that is improperly installed may be a hazard and could potentially cause injury or damage to persons to your home. To ensure years of window box satisfaction and longevity, we recommend you have a licensed contractor or qualified handyman install or advise you. We of course respect your decision to DIY.
The guidelines which follow are designed for the most common forms of exterior siding used on homes - specifically wood, shake/shingle, stucco, HardiBoard or vinyl. These are all surfaces that are supported by wood studs on the inside of the wall.
Using a Stud Finder (image), locate the studs on your wall in the area that you will be mounting your window box. Electronic or magnetic stud finders can be found at most local hardware stores. Simply drag the stud finder across the wall and look for the stud finder to signal the stud location. Most wood studs are found 16 on center but stud spacing underneath windows is varied and not always predictable. It is recommended that you mount your window box to as many studs as practical. When studs are found, mark lightly with pencil either on the window sill or directly below it (many people put a small "S" on their sill or wall to differentiate the stud locations from the center of the window which will be marked with a C in Step 2).
Once your supporting wall studs are found and marked, measure and mark the center of your window (mark this center-point on the sill or right below the sill with a C). Separately, with the box on the ground and using your tape measure, find and mark the center of your window box with a small C on the top edge of the back of the box.
With a partner, hold the window box up to the wall so that the C on the box matches the C on the sill. Once the Cs are aligned, step back and ensure you like the way the box is centered below the window. Adjust to your taste if necessary.
While holding the box to the wall with the two Cs aligned - mark on the top edge of the back of the box where the corresponding stud locations are on the wall. These will be the locations for you to drill pilot holes in the back of your window box (Step 4).
Locate on your wall where you would like the top of the window box to rest. Mark this box top height and using your 4 level draw a horizontal line across the wall.
Using a drill bit slightly smaller than the diameter of the bolts you will be using, drill a pilot hole into the back of the window box 2-3 inches down from the top of the box in-line with each S you have marked on the top edge of your box (drill holes from the outside in and drill the holes level to each other). Once drilled, these holes should ensure that the bolts will hit the studs while keeping the box centered below the window. It doesnt matter if the holes in the back of the box are spaced unevenly what matters is that they are spaced properly to hit each of the studs.
Once drilled, hold the box back up to the window aligning the two Cs that represent the center of the box and the center of the window. Using a pencil, nail or drill bit - from the inside of the box, mark the wall through the pilot holes in your box. Make sure the marks on the wall still align with your studs marked previously on your sill. Drill pilot holes into the wall.
With the washer between the bolt head and the box, secure the lag bolt through your pilot hole until your window box is securely fastened to your wall .